Prusa3D Forum

Notifiche

Cancella tutti

HAMMER_T

Gruppo: Registrato

Registrato: 2017/09/08

Active Member

	@RufusClupea, the eyes are with Sharpie, and the mouth with ... Nel forum Awesome prints (Hall Of Fame)	7 years fa
	This is the result with aceton smooting. For the Hungry Cat ... Nel forum Awesome prints (Hall Of Fame)	7 years fa
	The first thing is the extruder calibration. Only then you c... Nel forum Others (Archive)	7 years fa
	I have my power suply outside the enclosure. The temperature... Nel forum General discussion, announcements and releases	7 years fa
	Spots with rough texture on fine prints. Nel forum How do I print this? (Printing help)	7 years fa
	Sometimes I have the same problem with ABS. The solution is ... Nel forum Hardware, firmware and software help	7 years fa
	Last week I hat the same problem. It turns out, that the ext... Nel forum Prusa i3 kit (Archive)	8 years fa
	I have tried one time with ColorPrint, but the result was ve... Nel forum Improvements (Archive)	8 years fa

Statistiche Forum

585 Forum

68.2 K Discussioni

477.7 K Post

10 Online

75.9 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso