Notifications
Clear all
HAMMER_T
Groupe: Enregistré
A(ont) rejoint: 2017/09/08
Active Member
1
|
@RufusClupea, the eyes are with Sharpie, and the mouth with ... Dans le forum Awesome prints (Hall Of Fame) |
il y a 6 years | |
|
This is the result with aceton smooting. For the Hungry Cat ... Dans le forum Awesome prints (Hall Of Fame) |
il y a 6 years | |
|
The first thing is the extruder calibration. Only then you c... Dans le forum Others (Archive) |
il y a 7 years | |
|
I have my power suply outside the enclosure. The temperature... Dans le forum General discussion, announcements and releases |
il y a 7 years | |
|
Spots with rough texture on fine prints. Dans le forum How do I print this? (Printing help) |
il y a 7 years | |
|
Sometimes I have the same problem with ABS. The solution is ... Dans le forum Hardware, firmware and software help |
il y a 7 years | |
|
Last week I hat the same problem. It turns out, that the ext... Dans le forum Prusa i3 kit (Archive) |
il y a 7 years | |
|
I have tried one time with ColorPrint, but the result was ve... Dans le forum Improvements (Archive) |
il y a 7 years |