Notifications
Clear all
HackMonkey
HackMonkey
Groupe: Enregistré
A(ont) rejoint: 2017/09/22
Trusted Member
3
20% infill is probably fine. Generally, extra shells will ad...

Dans le forum Others (Archive)

il y a 7 years
I did some monitoring tonight running HTOP on the Pi Zero W ...

Dans le forum Others (Archive)

il y a 7 years
Correct, the Prusa provided image is much easier to setup. ...

Dans le forum General discussion, announcements and releases

il y a 7 years
PR has built an image that is preconfigured, but has only be...

Dans le forum General discussion, announcements and releases

il y a 7 years
You still need to do the basic setup for wi-fi, which is goi...

Dans le forum General discussion, announcements and releases

il y a 7 years
I have been runnning the RC5 firmware for several days now, ...

Dans le forum General discussion, announcements and releases

il y a 7 years
@paul.m27 - Have you also slowed down accelaeration as Josef...

Dans le forum General discussion, announcements and releases

il y a 7 years
The hardware side of the RPi Zero connection is covered in t...

Dans le forum User mods - OctoPrint, enclosures, nozzles, ...

il y a 7 years
I am using the "Prusa Print" Octopi image. As far as I can t...

Dans le forum General discussion, announcements and releases

il y a 7 years
reduce the travel speed to 200mm/s and infill acceleration f...

Dans le forum General discussion, announcements and releases

il y a 7 years
You can change the widths in the Advanced Print settings in ...

Dans le forum Others (Archive)

il y a 7 years
Definitely check with some other filament. I print mostly wi...

Dans le forum Others (Archive)

il y a 7 years
Warping is all about temperature difference. Call it what yo...

Dans le forum Others (Archive)

il y a 7 years
Check for drafts. I hadn't had any issues at all, until just...

Dans le forum Others (Archive)

il y a 7 years
The current Octoprint setup is working pretty solid for me. ...

Dans le forum Others (Archive)

il y a 7 years
The "Prusa Print" version of Octopi should be added to the l...

Dans le forum General discussion, announcements and releases

il y a 7 years
Thing is, Octoprint is open source. So there is always going...

Dans le forum Others (Archive)

il y a 7 years
You can automate it by slicing with Prusa Control, and then ...

Dans le forum Others (Archive)

il y a 7 years
I suppose you could always print a new cover with the button...

Dans le forum Others (Archive)

il y a 7 years
Sure, we can hack together any kind of profile we want on ou...

Dans le forum Others (Archive)

il y a 7 years
Page 3 / 5
Partager :