|
@Snuffleupagus Thanks for being so kind in your reply. I ju... Nel forum PrusaSlicer |
7 months fa |
|
Organic supports with gaps Nel forum PrusaSlicer |
7 months fa |
|
I tried that and it would not move the folder. But I made a... Nel forum General discussion, announcements and releases |
2 years fa |
|
I updated my models and I put the older STL's in a folder na... Nel forum General discussion, announcements and releases |
2 years fa |
|
Thanks for the replies. That makes sense. Much appreciated... Nel forum General discussion, announcements and releases |
2 years fa |
|
Correct way to post updated models on Printables Nel forum General discussion, announcements and releases |
2 years fa |
|
That was it. Thanks so much!!! I never thought to check th... Nel forum PrusaSlicer |
2 years fa |
|
Why does print speed change when object is consistently the ... Nel forum PrusaSlicer |
2 years fa |
|
PrusaSlicer 2.4.0 and Configuration update Nel forum PrusaSlicer |
3 years fa |
|
@swiss_cheese Thank you so much for taking the time to expla... Nel forum PrusaSlicer |
3 years fa |
|
@swiss_cheese Thanks for all the information. It was very u... Nel forum PrusaSlicer |
3 years fa |
|
@neophyl Thanks for the file. I may give this one a try. B... Nel forum PrusaSlicer |
3 years fa |
|
Hello sylviatrilling, Thanks for the advice. I may give tha... Nel forum PrusaSlicer |
3 years fa |
|
Thanks Neophyl,
I realize I did not state that I was using... Nel forum PrusaSlicer |
3 years fa |
|
Support question in 2.4.0 RC2 Nel forum PrusaSlicer |
3 years fa |
|
I just left a reply on another post about power cords. I ju... Nel forum Others (Archive) |
5 years fa |
|
What is the draw of the device? I have built an enclosure a... Nel forum Hardware, firmware and software help |
5 years fa |
|
Hi,
what are the pro's and con's of turning on/off magnet co... Nel forum General discussion, announcements and releases |
6 years fa |
|
I finally see a listing on Amazon but no availability yet so... Nel forum General discussion, announcements and releases |
6 years fa |
|
Ok then I understand.
Your X-carriage back on the extruder i... Nel forum Assembly and first prints troubleshooting |
6 years fa |
