Notifications
Clear all
gminnick
gminnick
Group: Registered
Joined: 2018/09/25
Eminent Member
2
I tried that and it would not move the folder. But I made a...

In forum General discussion, announcements and releases

7 months ago
I updated my models and I put the older STL's in a folder na...

In forum General discussion, announcements and releases

7 months ago
Thanks for the replies. That makes sense. Much appreciated...

In forum General discussion, announcements and releases

8 months ago
Correct way to post updated models on Printables

In forum General discussion, announcements and releases

8 months ago
That was it. Thanks so much!!! I never thought to check th...

In forum PrusaSlicer

12 months ago
Why does print speed change when object is consistently the ...

In forum PrusaSlicer

12 months ago
PrusaSlicer 2.4.0 and Configuration update

In forum PrusaSlicer

2 years ago
@swiss_cheese Thank you so much for taking the time to expla...

In forum PrusaSlicer

2 years ago
@swiss_cheese Thanks for all the information. It was very u...

In forum PrusaSlicer

2 years ago
@neophyl Thanks for the file. I may give this one a try. B...

In forum PrusaSlicer

2 years ago
Hello sylviatrilling, Thanks for the advice. I may give tha...

In forum PrusaSlicer

2 years ago
Thanks Neophyl, I realize I did not state that I was using...

In forum PrusaSlicer

2 years ago
Support question in 2.4.0 RC2

In forum PrusaSlicer

2 years ago
I just left a reply on another post about power cords. I ju...

In forum Others (Archive)

4 years ago
What is the draw of the device? I have built an enclosure a...

In forum Hardware, firmware and software help

4 years ago
Hi, what are the pro's and con's of turning on/off magnet co...

In forum General discussion, announcements and releases

5 years ago
I finally see a listing on Amazon but no availability yet so...

In forum General discussion, announcements and releases

5 years ago
Ok then I understand. Your X-carriage back on the extruder i...

In forum Assembly and first prints troubleshooting

5 years ago
Why not just turn it in the right direction? I mounted it ...

In forum Assembly and first prints troubleshooting

5 years ago
If you have mounted the spool holder back and forth, then yo...

In forum Assembly and first prints troubleshooting

5 years ago
Page 1 / 2
Share: