Prusa3D Forum

Notifications

Clear all

glenn-skala

Groupe: Enregistré

A(ont) rejoint: 2024/06/14

Active Member

	RE: Stuck filament detection causing filament to get stuck? Dans le forum Hardware, firmware and software help	il y a 3 months
	I've been having success printing PETG after re-flashing bac... Dans le forum Hardware, firmware and software help	il y a 3 months
	I think most if the stuck filament issues mentioned in this ... Dans le forum Hardware, firmware and software help	il y a 3 months
	I made all the upgrades provided by Prusa as part of the enc... Dans le forum Hardware, firmware and software help	il y a 3 months
	Bernard, Thank you for putting this together. I have recen... Dans le forum PrusaSlicer	il y a 4 months
	I did run across this bug reported a couple weeks ago on git... Dans le forum Hardware, firmware and software help	il y a 4 months
	Here's a link to another thread around chronic stuck filamen... Dans le forum Assembly and first prints troubleshooting	il y a 4 months
	I reflashed my Xl (prior post on this thread) back to V 6.0.... Dans le forum Hardware, firmware and software help	il y a 4 months
	Yesterday I started getting stuck filament errors on my XL (... Dans le forum Hardware, firmware and software help	il y a 4 months
	I've recently received, assembled and installed the Prusa En... Dans le forum Assembly and first prints troubleshooting	il y a 4 months

Statistiques du forum

559 Forums

63.1 K Sujets

443.9 K Messages

21 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé