Notifications
Clear all
Getahobbie
Getahobbie
Groupe: Enregistré
A(ont) rejoint: 2019/06/26
Active Member
1
Just checking...did you glue the G10 to the Prusa spring ste...

Dans le forum User mods - OctoPrint, enclosures, nozzles, ...

il y a 2 years
In the new version (2.3.2) they say they've fixed the issue ...

Dans le forum PrusaSlicer

il y a 3 years
M600, what commands are included in the color change command...

Dans le forum PrusaSlicer

il y a 4 years
I'm try to keep the solid infill layer from going (seemingly...

Dans le forum PrusaSlicer

il y a 4 years
In PrusaSlicer, my "Fill pattern" is set to grid and Monoton...

Dans le forum PrusaSlicer

il y a 4 years
My solid infill is all over the place, printing in patches t...

Dans le forum PrusaSlicer

il y a 4 years
Nevermind, I figured it out. It was indeed the alpha0 that ...

Dans le forum PrusaSlicer

il y a 4 years
I was using the new alpha alongside prusaslicer_2.2 and an e...

Dans le forum PrusaSlicer

il y a 4 years
I hear you. That's usually what I'm doing but more recently...

Dans le forum General discussion, announcements and releases

il y a 4 years
@jsw Sorry, I should rephrase the question to "Why do you pr...

Dans le forum General discussion, announcements and releases

il y a 4 years
@jsw Why do you prefer to heat up the bed?

Dans le forum General discussion, announcements and releases

il y a 4 years
I suggest that the Prusa temp settings (Settings > Temperatu...

Dans le forum General discussion, announcements and releases

il y a 4 years
@neophyl I didn't see an ".exe" in the Zip file. Am I missi...

Dans le forum PrusaSlicer

il y a 5 years
I just got this issue on my MK3S with the older 3.8.0 firmwa...

Dans le forum PrusaSlicer

il y a 5 years
I've been in contact with support. I was so desperate to ge...

Dans le forum Hardware, firmware and software help

il y a 5 years
Did you ever get this resolved? I'm having the same issue.

Dans le forum Hardware, firmware and software help

il y a 5 years
I think I'm having the same issue. How did they determine t...

Dans le forum Hardware, firmware and software help

il y a 5 years
Partager :