Notifications
Clear all
gamefe
Skupina: Registrovaný
Přidal se: 2021/09/21
Active Member
1
| disassembled, cleaned reassembled. I tried to screw it toget... | před 4 years | |
| 65566923528__FBB989F9-A5E3-4A3E-A3C6-9615C3A6C6C7 | před 4 years | |
| Leaking again | před 4 years | |
| This is the print on the as card from factory. I didn’t desi... | před 4 years | |
| did as you suggested. Washed, isopropyl alcohol, wipe. Print... | před 4 years | |
| Not correct. | před 4 years | |
| Benchy reload | před 4 years | |
| Washed surface with windex. Then with isopropyl alcohol, the... | před 4 years | |
| First the print that popped off at roof then print that held... | před 4 years | |
| So I rebuilt the hotted, that took hours between blockages, ... | před 4 years | |
| I rebuilt the printer. Retightened the X belt, Y Belt, Bed, ... | před 4 years | |
| I turned it off. Printed the cube at 400% tall. no octoprin... | před 4 years | |
| X shifting at same height | před 4 years |