Prusa3D Forum

Notifications

Clear all

frjones

Groupe: Enregistré

A(ont) rejoint: 2021/07/24

Active Member

	Thanks for the detailed reply Neophyl. I appreciate it. Yes ... Dans le forum PrusaSlicer	il y a 1 year
	Sry, didn't realize that was needed. attached. fjone... Dans le forum PrusaSlicer	il y a 1 year
	internal part supports - not to base Dans le forum PrusaSlicer	il y a 1 year
	I think I've figured out what's going on. I had spool-join e... Dans le forum Hardware, firmware and software help	il y a 3 years
	If you go to the plater > filaments, if you click on the ... Dans le forum Hardware, firmware and software help	il y a 3 years
	printer unloads/reloads (sometimes random filiment) and fail... Dans le forum Hardware, firmware and software help	il y a 3 years
	I just was reading this: seems similar. fj.. Dans le forum How do I print this? (Printing help)	il y a 3 years
	Temperature change before retraction... Dans le forum Hardware, firmware and software help	il y a 3 years
	update: failed again with MMU needs attention error. went in... Dans le forum How do I print this? (Printing help)	il y a 3 years
	The ball in the FINDA sensor seemed to be randomly sticking.... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Problems printing with MMU2S with BVOH filiment. Dans le forum How do I print this? (Printing help)	il y a 3 years

Statistiques du forum

566 Forums

63.2 K Sujets

444.2 K Messages

23 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé