Notifications
Clear all
frause
Skupina: Registrovaný
Přidal se: 2025/06/05
Active Member
1
|
I've gone though various iterations. For now I've settled wi... In forum Hardware, firmware and software help |
před 1 month | |
|
Sure. This is the whole End G-code section. {if layer_z <... In forum Hardware, firmware and software help |
před 2 months | |
|
Oh, interesting! What info can you change in an existing tag... In forum OpenPrintTag |
před 2 months | |
|
The Prusa app says it can... In forum OpenPrintTag |
před 2 months | |
| Oh, you are right! I didn't think that one completely throug... | před 2 months | |
| I believe you only need the M870 C in the End G-code. The fi... | před 2 months | |
|
This seems to work well, with a few changes. Like actually w... In forum Hardware, firmware and software help |
před 2 months | |
| Thank you! I was so sure the tube length was set correctly b... | před 2 months | |
|
Mine does this too. I don't know. My theory is it is the tip... In forum Hardware, firmware and software help |
před 6 months |