|
Thanks for the help! I'll try giving drying the filament a g... In forum How do I print this? (Printing help) |
11 months ago |
|
Turns out it was some dodgy print settings applied by someon... In forum How do I print this? (Printing help) |
11 months ago |
|
Why are my prints turning out blotchy and brown? In forum How do I print this? (Printing help) |
11 months ago |
|
Heya! I've attached the file below, cheers!
71f907cc... In forum How do I print this? (Printing help) |
11 months ago |
|
Model on model supports not adhering In forum How do I print this? (Printing help) |
11 months ago |
|
TPU overhang layering artifacts In forum How do I print this? (Printing help) |
11 months ago |
|
Really appreciate all the detailed insights guys - I'll do s... In forum How do I print this? (Printing help) |
2 years ago |
|
Printing TPU on the MK4 In forum How do I print this? (Printing help) |
2 years ago |
|
High temperature filament MAX TEMP reached failure In forum How do I print this? (Printing help) |
2 years ago |
|
Just want to post on this thread with an update - I wasn't f... In forum How do I print this? (Printing help) |
2 years ago |
|
That's very clever! I appreciate the advice, I will definite... In forum Hardware, firmware and software help |
2 years ago |
|
Printer X axis rattle In forum Hardware, firmware and software help |
2 years ago |
|
Flexible filament fails at consistent intervals In forum How do I print this? (Printing help) |
2 years ago |
|
Can confirm, nozzle replacement seemed to do the trick! I st... In forum Hardware, firmware and software help |
2 years ago |
|
I haven't tried that yet - do you reckon that could be a cau... In forum Hardware, firmware and software help |
2 years ago |
|
Flexible filament no longer loading In forum Hardware, firmware and software help |
2 years ago |
|
Update, if I press down slightly on the bed the rattling noi... In forum Hardware, firmware and software help |
2 years ago |
|
Printer bed rattling noise In forum Hardware, firmware and software help |
2 years ago |
|
I appreciate the response!
But forgive me, I still can't e... In forum How do I print this? (Printing help) |
2 years ago |
|
Fair enough yeah I wouldn't put too much weight behind the v... In forum How do I print this? (Printing help) |
2 years ago |
