Prusa3D Forum

Notifications

Clear all

FigFire

Grupa: Zarejestrowany

Dołączył: 2021/06/30

Active Member

	Thanks for the explanation and advice. I think I will just ... In forum Hardware, firmware and software help	2 years temu
	This is the game plan, thank you so much for the help. In forum Hardware, firmware and software help	2 years temu
	Exposed wire from melted insulation/frayed braid around heat... In forum Hardware, firmware and software help	2 years temu
	@diem I'll try to do this periodically, with or without glue... In forum Hardware, firmware and software help	3 years temu
	@dan-rogers The first layers are stuck then the layer shift ... In forum Hardware, firmware and software help	3 years temu
	Prints shifting after a few layers In forum Hardware, firmware and software help	3 years temu

Statystyki Forum

559 Fora

63 K Tematy

443.2 K Posty

19 Online

67.8 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte