Prusa3D Forum

Notifications

Clear all

FigFire

Skupina: Registrovaný

Přidal se: 2021/06/30

Active Member

	Thanks for the explanation and advice. I think I will just ... In forum Hardware, firmware and software help	před 2 years
	This is the game plan, thank you so much for the help. In forum Hardware, firmware and software help	před 2 years
	Exposed wire from melted insulation/frayed braid around heat... In forum Hardware, firmware and software help	před 2 years
	@diem I'll try to do this periodically, with or without glue... In forum Hardware, firmware and software help	před 3 years
	@dan-rogers The first layers are stuck then the layer shift ... In forum Hardware, firmware and software help	před 3 years
	Prints shifting after a few layers In forum Hardware, firmware and software help	před 3 years

Fórum Statistiky

559 Fóra

63 K Témata

443.2 K Příspěvky

22 Online

67.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed