Prusa3D Forum

Notifiche

Cancella tutti

FigFire

Gruppo: Registrato

Registrato: 2021/06/30

Active Member

	Thanks for the explanation and advice. I think I will just ... Nel forum Hardware, firmware and software help	2 years fa
	This is the game plan, thank you so much for the help. Nel forum Hardware, firmware and software help	2 years fa
	Exposed wire from melted insulation/frayed braid around heat... Nel forum Hardware, firmware and software help	2 years fa
	@diem I'll try to do this periodically, with or without glue... Nel forum Hardware, firmware and software help	3 years fa
	@dan-rogers The first layers are stuck then the layer shift ... Nel forum Hardware, firmware and software help	3 years fa
	Prints shifting after a few layers Nel forum Hardware, firmware and software help	3 years fa

Statistiche Forum

559 Forum

63 K Discussioni

443.2 K Post

20 Online

67.8 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso