Notifications
Clear all
Farris Goldstein
Group: Registered
Joined: 2019/12/14
Active Member
1
|
Thanks! Should I file an issue in GitHub? Also, the forum ... In forum PrusaSlicer |
4 years ago | |
|
Does your infill percentage actually change at 18mm, the top... In forum PrusaSlicer |
4 years ago | |
|
Take three.
Attachment removed In forum PrusaSlicer |
4 years ago | |
|
Am I too new to attach files? Or is there something wrong wi... In forum PrusaSlicer |
4 years ago | |
|
Yep, I definitely zipped it. I tried again, and I see an "! ... In forum PrusaSlicer |
4 years ago | |
|
Chose a file to attach, then added the Reply, but I don't se... In forum PrusaSlicer |
4 years ago | |
|
3mf file attached. In forum PrusaSlicer |
4 years ago | |
|
Just to clarify: That solid-looking section in the center is... In forum PrusaSlicer |
4 years ago | |
|
Height range modifier infill settings not applied In forum PrusaSlicer |
4 years ago | |
|
This far I have avoided having to manually pull filament out... In forum Hardware, firmware and software help |
6 years ago | |
|
Notches and dents in filament? In forum Hardware, firmware and software help |
6 years ago |