Prusa3D Forum

Notifications

Clear all

EvilPenguin

Grupa: Zarejestrowany

Dołączył: 2017/07/29

Active Member

	Thanks Joan, You've been really helpful in the past and con... In forum Hardware, firmware and software help	7 years temu
	PINDA cable failure?? In forum Hardware, firmware and software help	7 years temu
	Solved, I think! Successfully printed out a Benchy. It was ... In forum Prusa i3 kit (Archive)	7 years temu
	It's definitely the model. But, I'm still confused and I've ... In forum Prusa i3 kit (Archive)	7 years temu
	New development: I went over EVERYTHING again. This time I ... In forum Prusa i3 kit (Archive)	7 years temu
	If the bed still heats up you should not need a new one. It... In forum Prusa i3 kit (Archive)	7 years temu
	Filament stops extruding after random number of layers In forum Prusa i3 kit (Archive)	7 years temu
	That is a photo of the MK2 - so it is both the heat bed and ... In forum Prusa i3 kit (Archive)	7 years temu
	Okay... all of this makes me feel a little better. I didn't... In forum Prusa i3 kit (Archive)	7 years temu
	I ran calibration test and destroyed my bed In forum Prusa i3 kit (Archive)	7 years temu

Statystyki Forum

559 Fora

62.9 K Tematy

442.8 K Posty

19 Online

67.6 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte