Prusa3D Forum

Notifications

Clear all

EvilPenguin

Skupina: Registrovaný

Přidal se: 2017/07/29

Active Member

	Thanks Joan, You've been really helpful in the past and con... In forum Hardware, firmware and software help	před 7 years
	PINDA cable failure?? In forum Hardware, firmware and software help	před 7 years
	Solved, I think! Successfully printed out a Benchy. It was ... In forum Prusa i3 kit (Archive)	před 7 years
	It's definitely the model. But, I'm still confused and I've ... In forum Prusa i3 kit (Archive)	před 7 years
	New development: I went over EVERYTHING again. This time I ... In forum Prusa i3 kit (Archive)	před 7 years
	If the bed still heats up you should not need a new one. It... In forum Prusa i3 kit (Archive)	před 7 years
	Filament stops extruding after random number of layers In forum Prusa i3 kit (Archive)	před 7 years
	That is a photo of the MK2 - so it is both the heat bed and ... In forum Prusa i3 kit (Archive)	před 7 years
	Okay... all of this makes me feel a little better. I didn't... In forum Prusa i3 kit (Archive)	před 7 years
	I ran calibration test and destroyed my bed In forum Prusa i3 kit (Archive)	před 7 years

Fórum Statistiky

559 Fóra

62.9 K Témata

442.8 K Příspěvky

18 Online

67.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed