Prusa3D Forum

Notifications

Clear all

EvilPenguin

Groupe: Enregistré

A(ont) rejoint: 2017/07/29

Active Member

	Thanks Joan, You've been really helpful in the past and con... Dans le forum Hardware, firmware and software help	il y a 7 years
	PINDA cable failure?? Dans le forum Hardware, firmware and software help	il y a 7 years
	Solved, I think! Successfully printed out a Benchy. It was ... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	It's definitely the model. But, I'm still confused and I've ... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	New development: I went over EVERYTHING again. This time I ... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	If the bed still heats up you should not need a new one. It... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Filament stops extruding after random number of layers Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	That is a photo of the MK2 - so it is both the heat bed and ... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Okay... all of this makes me feel a little better. I didn't... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	I ran calibration test and destroyed my bed Dans le forum Prusa i3 kit (Archive)	il y a 7 years

Statistiques du forum

565 Forums

63.9 K Sujets

447.7 K Messages

21 En-ligne

69.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé