|
Thanks, both of you. And looking very closely, I see that th... In forum Hardware, firmware and software help |
4 years ago |
|
"z leveling enforced" In forum Hardware, firmware and software help |
4 years ago |
|
Cold Pull Gone Wrong In forum Hardware, firmware and software help |
5 years ago |
|
Thank you for the advice - that was very helpful on a fundam... In forum Hardware, firmware and software help |
6 years ago |
|
Mesh Bed Leveling Fail In forum Hardware, firmware and software help |
6 years ago |
|
Oops - I see that I've posted this in the MK3 forum instead ... In forum Hardware, firmware and software help |
6 years ago |
|
Z Calibration Fail In forum Hardware, firmware and software help |
6 years ago |
|
But wouldn't whatever pulled he extruder out of whack have b... In forum Others (Archive) |
8 years ago |
|
That looks like the same problem, but maybe a different caus... In forum Others (Archive) |
8 years ago |
|
Thanks for the advice. Belts look good, and the bundle of ca... In forum Others (Archive) |
8 years ago |
|
Uh oh - not so fast. After switching to the Prusa edition of... In forum Others (Archive) |
8 years ago |
|
Thanks, everyone. It was the filament diameter setting in Cu... In forum Others (Archive) |
8 years ago |
|
I bought this printer assembled, so chances are that it's no... In forum Others (Archive) |
8 years ago |
|
Layer Offset Fail In forum Others (Archive) |
8 years ago |
