|
These pictures and this code were a Godsend! Thank you very... In forum Assembly and first prints troubleshooting |
8 years ago |
|
The end of the story --
As it turns out, the PINDA was fine... In forum Assembly and first prints troubleshooting |
8 years ago |
|
Suggestions on how to proceed? In forum Assembly and first prints troubleshooting |
8 years ago |
|
Interesting. I can get the PINDA probe to flash by putting ... In forum Assembly and first prints troubleshooting |
8 years ago |
|
Thanks for that idea, but that is not something I have layin... In forum Assembly and first prints troubleshooting |
8 years ago |
|
Ferrous metal attached to the bed did nothing to change the ... In forum Assembly and first prints troubleshooting |
8 years ago |
|
"this should allow a correct detection of the printbed inlay... In forum Assembly and first prints troubleshooting |
8 years ago |
|
Anyone with additional ideas? In forum Assembly and first prints troubleshooting |
8 years ago |
|
The base of mine is illuminated where it connects to the cab... In forum Assembly and first prints troubleshooting |
8 years ago |
|
I understand that, however, the PINDA cannot go any lower wi... In forum Assembly and first prints troubleshooting |
8 years ago |
|
Thank you.
I have verified that the Y axis is completely do... In forum Assembly and first prints troubleshooting |
8 years ago |
|
I forgot to mention - yes the bed is heated. In forum Assembly and first prints troubleshooting |
8 years ago |
|
Print nozzle hitting bed with PINDA all the way down. In forum Assembly and first prints troubleshooting |
8 years ago |
