Prusa3D Forum

Notifications

Clear all

DiscoJon

Groupe: Enregistré

A(ont) rejoint: 2018/02/15

Active Member

	Unecessary purge in mid air at end of print Dans le forum PrusaSlicer	il y a 5 years
	Why no bearing on lead screw top? Dans le forum Others (Archive)	il y a 7 years
	F3d or step is great. Thanks! Dans le forum Hardware, firmware and software help	il y a 7 years
	Does anyone have a solid file for the einsy base? I'd like... Dans le forum Hardware, firmware and software help	il y a 7 years
	Thanks for following up. Dans le forum Others (Archive)	il y a 7 years
	Is there any benefit to using the headers? Increased speeds... Dans le forum Others (Archive)	il y a 7 years
	Does anyone have a solid file for the einsy base? I'd like... Dans le forum Hardware, firmware and software help	il y a 7 years
	I use a PI3 attached to the headers no problem. I fabricate... Dans le forum Others (Archive)	il y a 7 years
	I actually found a decent solution to mount a full sized pi ... Dans le forum Others (Archive)	il y a 7 years
	Does anyone have a solid file for the einsy base? I'd like... Dans le forum Hardware, firmware and software help	il y a 7 years
	I'm sure I could. I just like having the cleanliness of eve... Dans le forum Others (Archive)	il y a 7 years
	Thanks for the info. Is there an alternative +5v source on ... Dans le forum Others (Archive)	il y a 7 years
	The plan would be to make a removable panel on the electroni... Dans le forum Others (Archive)	il y a 7 years
	Full size raspberry pi in place of zero? Dans le forum Others (Archive)	il y a 7 years

Statistiques du forum

559 Forums

62 K Sujets

438.8 K Messages

18 En-ligne

67.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé