Prusa3D Forum

Notifications

Clear all

DiscoJon

Skupina: Registrovaný

Přidal se: 2018/02/15

Active Member

	Unecessary purge in mid air at end of print In forum PrusaSlicer	před 5 years
	Why no bearing on lead screw top? In forum Others (Archive)	před 7 years
	F3d or step is great. Thanks! In forum Hardware, firmware and software help	před 7 years
	Does anyone have a solid file for the einsy base? I'd like... In forum Hardware, firmware and software help	před 7 years
	Thanks for following up. In forum Others (Archive)	před 7 years
	Is there any benefit to using the headers? Increased speeds... In forum Others (Archive)	před 7 years
	Does anyone have a solid file for the einsy base? I'd like... In forum Hardware, firmware and software help	před 7 years
	I use a PI3 attached to the headers no problem. I fabricate... In forum Others (Archive)	před 7 years
	I actually found a decent solution to mount a full sized pi ... In forum Others (Archive)	před 7 years
	Does anyone have a solid file for the einsy base? I'd like... In forum Hardware, firmware and software help	před 7 years
	I'm sure I could. I just like having the cleanliness of eve... In forum Others (Archive)	před 7 years
	Thanks for the info. Is there an alternative +5v source on ... In forum Others (Archive)	před 7 years
	The plan would be to make a removable panel on the electroni... In forum Others (Archive)	před 7 years
	Full size raspberry pi in place of zero? In forum Others (Archive)	před 7 years

Fórum Statistiky

565 Fóra

64.5 K Témata

451.9 K Příspěvky

20 Online

71.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed