Prusa3D Forum

Notifications

Clear all

Dirk S.

Skupina: Registrovaný

Přidal se: 2017/02/14

Active Member

	I‘m also an owner of the first MMU generation and I have had... In forum General discussion, announcements and releases	před 7 years
	As already mentioned a couple of times I‘ve been fighting wi... In forum Others (Archive)	před 7 years
	Honestly spoken the MK2S is really not bad and very reliable... In forum Others (Archive)	před 7 years
	I‘m also done with the MMU and PRUSA as well!!! Wasted so ma... In forum Others (Archive)	před 7 years
	I’ve swapped back to my original MK2S hotend with some inter... In forum Others (Archive)	před 7 years
	I fully agree with henrik and start to believe that Prusa is... In forum Assembly and first prints troubleshooting	před 7 years
	The spring tension is exactly set to 5mm between body and wa... In forum Others (Archive)	před 7 years
	I’m already very disappointed to read about that clogging is... In forum Others (Archive)	před 7 years
	This is the answer I’ve got from the Prusa support: So you ... In forum Others (Archive)	před 7 years
	Check the thread jamming-in-the-steel-tubes - here in the fo... In forum Others (Archive)	před 7 years
	Some updates... – temp fluctuations of the nozzle is solved ... In forum Hardware, firmware and software help	před 7 years
	I would like to share my communication I had with the Prusa ... In forum Hardware, firmware and software help	před 7 years
	Hey, still facing with the exactly same issue of clogging d... In forum Others (Archive)	před 7 years
	I‘m also fighting with jamming … but in my case it starts al... In forum Hardware, firmware and software help	před 7 years
	Lot of trouble with clogging after upgrade to MM In forum Others (Archive)	před 7 years

Fórum Statistiky

559 Fóra

63 K Témata

443.6 K Příspěvky

19 Online

67.9 K Uživatelé

Poslední Příspěvek: Tiny print job help Nový Uživatel: etiennep Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed