Prusa3D Forum

Notifications

Clear all

devvrider

Groupe: Enregistré

A(ont) rejoint: 2020/12/24

Active Member

	May I know what resin and exposure time are you on? Dans le forum General discussion, announcements and releases	il y a 3 years
	Vat Tilting Motor skipping and hitting the print bed? Dans le forum General discussion, announcements and releases	il y a 3 years
	Thanks for the info folks. I do think the nail polish contai... Dans le forum Hardware, firmware and software help	il y a 3 years
	Smooth PEI sheet adhension after cleaning with acetone Dans le forum Hardware, firmware and software help	il y a 3 years
	An update on the issue: There is a huge hole appearing on my... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Thank you, I have done a complete clean up again, it turned ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Uneven defects on print over same LCD area Dans le forum How do I print this? (Printing help)	il y a 4 years
	Remove failed resin residue on FEP? Dans le forum Hardware, firmware and software help	il y a 4 years
	Visible Layers on prints Dans le forum How do I print this? (Printing help)	il y a 4 years
	@gnat Thanks, platform leveling do you mean the whole SL1 ma... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Support structure strength issue Dans le forum How do I print this? (Printing help)	il y a 5 years

Statistiques du forum

585 Forums

68.3 K Sujets

478.1 K Messages

12 En-ligne

76 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé