Prusa3D Forum

Notifications

Clear all

devvrider

Skupina: Registrovaný

Přidal se: 2020/12/24

Active Member

	May I know what resin and exposure time are you on? In forum General discussion, announcements and releases	před 3 years
	Vat Tilting Motor skipping and hitting the print bed? In forum General discussion, announcements and releases	před 3 years
	Thanks for the info folks. I do think the nail polish contai... In forum Hardware, firmware and software help	před 3 years
	Smooth PEI sheet adhension after cleaning with acetone In forum Hardware, firmware and software help	před 3 years
	An update on the issue: There is a huge hole appearing on my... In forum How do I print this? (Printing help)	před 4 years
	Thank you, I have done a complete clean up again, it turned ... In forum How do I print this? (Printing help)	před 4 years
	Uneven defects on print over same LCD area In forum How do I print this? (Printing help)	před 4 years
	Remove failed resin residue on FEP? In forum Hardware, firmware and software help	před 4 years
	Visible Layers on prints In forum How do I print this? (Printing help)	před 5 years
	@gnat Thanks, platform leveling do you mean the whole SL1 ma... In forum How do I print this? (Printing help)	před 5 years
	Support structure strength issue In forum How do I print this? (Printing help)	před 5 years

Fórum Statistiky

595 Fóra

69.2 K Témata

484 K Příspěvky

15 Online

78.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed