Prusa3D Forum

Notifications

Clear all

DesignFlaw06

Groupe: Enregistré

A(ont) rejoint: 2016/10/29

Active Member

	My guess is that the MK2.5/3 MMU will have one filament sens... Dans le forum Others (Archive)	il y a 7 years
	So many unanswered questions about upgrades between MMU, MK2... Dans le forum Others (Archive)	il y a 7 years
	The minimum layer height is 0.15mm and variable height isn't... Dans le forum Others (Archive)	il y a 7 years
	Just my .02, don't throw out your troublesome filaments, giv... Dans le forum Others (Archive)	il y a 7 years
	Someone said that abrasive filaments cannot be used in the M... Dans le forum Others (Archive)	il y a 7 years
	Could slowing the retraction speed help at all? Dans le forum Others (Archive)	il y a 7 years
	is stringing just a fact of life with the mmu? It shouldn'... Dans le forum Others (Archive)	il y a 7 years
	So the only success I've really had with MakerGeeks so far i... Dans le forum Others (Archive)	il y a 7 years
	MakerGeeks Filament with MMU Dans le forum Others (Archive)	il y a 8 years
	Did you look at the connector for the heated bed ? The conn... Dans le forum Others (Archive)	il y a 8 years
	Just an idea but check that the zip tie "nubs" are in the co... Dans le forum Others (Archive)	il y a 8 years
	There are a few things to try: First check the probe is wor... Dans le forum Others (Archive)	il y a 8 years
	Can't find calibration point 2 out of 4 - Help please! Dans le forum Others (Archive)	il y a 8 years
	I ordered mine on October 30th. I also ordered the quad-mat... Dans le forum General discussion, announcements and releases	il y a 8 years

Statistiques du forum

565 Forums

63.8 K Sujets

447.2 K Messages

21 En-ligne

69.3 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé