Prusa3D Forum

Notifications

Clear all

DesignFlaw06

Skupina: Registrovaný

Přidal se: 2016/10/29

Active Member

	My guess is that the MK2.5/3 MMU will have one filament sens... In forum Others (Archive)	před 8 years
	So many unanswered questions about upgrades between MMU, MK2... In forum Others (Archive)	před 8 years
	The minimum layer height is 0.15mm and variable height isn't... In forum Others (Archive)	před 8 years
	Just my .02, don't throw out your troublesome filaments, giv... In forum Others (Archive)	před 8 years
	Someone said that abrasive filaments cannot be used in the M... In forum Others (Archive)	před 8 years
	Could slowing the retraction speed help at all? In forum Others (Archive)	před 8 years
	is stringing just a fact of life with the mmu? It shouldn'... In forum Others (Archive)	před 8 years
	So the only success I've really had with MakerGeeks so far i... In forum Others (Archive)	před 8 years
	MakerGeeks Filament with MMU In forum Others (Archive)	před 8 years
	Did you look at the connector for the heated bed ? The conn... In forum Others (Archive)	před 9 years
	Just an idea but check that the zip tie "nubs" are in the co... In forum Others (Archive)	před 9 years
	There are a few things to try: First check the probe is wor... In forum Others (Archive)	před 9 years
	Can't find calibration point 2 out of 4 - Help please! In forum Others (Archive)	před 9 years
	I ordered mine on October 30th. I also ordered the quad-mat... In forum General discussion, announcements and releases	před 9 years

Fórum Statistiky

585 Fóra

68 K Témata

476.8 K Příspěvky

13 Online

75.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed