|
same settings, only changed the brand of filament 😯 Dans le forum Others (Archive) |
il y a 8 years |
|
I think carsten has hit the problem, I have always had probl... Dans le forum Others (Archive) |
il y a 8 years |
|
I finally got to test your gcode. Printing is improved but u... Dans le forum Others (Archive) |
il y a 8 years |
|
I have already done a lot of testing, but I'll try again. Wh... Dans le forum Others (Archive) |
il y a 8 years |
|
Your prints are very good, with some finishing will be perfe... Dans le forum Others (Archive) |
il y a 8 years |
|
i'm attaching the file Dans le forum Others (Archive) |
il y a 8 years |
|
Of course, the fan is set to maximum. I did also attempts de... Dans le forum Others (Archive) |
il y a 8 years |
|
I tried printing from outside to inside, just a little bette... Dans le forum Others (Archive) |
il y a 8 years |
|
This is a continuous perimeter, I thought that the retractio... Dans le forum Others (Archive) |
il y a 8 years |
|
printing problem at 0.1mm PLA Dans le forum Others (Archive) |
il y a 8 years |
|
I printed marvin and it came out perfectly, the problem happ... Dans le forum Others (Archive) |
il y a 8 years |
|
hi,
I have the same problem, even on other models, you have ... Dans le forum Others (Archive) |
il y a 8 years |
