|
same settings, only changed the brand of filament 😯 In forum Others (Archive) |
před 8 years |
|
I think carsten has hit the problem, I have always had probl... In forum Others (Archive) |
před 8 years |
|
I finally got to test your gcode. Printing is improved but u... In forum Others (Archive) |
před 8 years |
|
I have already done a lot of testing, but I'll try again. Wh... In forum Others (Archive) |
před 8 years |
|
Your prints are very good, with some finishing will be perfe... In forum Others (Archive) |
před 8 years |
|
i'm attaching the file In forum Others (Archive) |
před 8 years |
|
Of course, the fan is set to maximum. I did also attempts de... In forum Others (Archive) |
před 8 years |
|
I tried printing from outside to inside, just a little bette... In forum Others (Archive) |
před 8 years |
|
This is a continuous perimeter, I thought that the retractio... In forum Others (Archive) |
před 8 years |
|
printing problem at 0.1mm PLA In forum Others (Archive) |
před 8 years |
|
I printed marvin and it came out perfectly, the problem happ... In forum Others (Archive) |
před 8 years |
|
hi,
I have the same problem, even on other models, you have ... In forum Others (Archive) |
před 8 years |
