|
same settings, only changed the brand of filament 😯 En el foro Others (Archive) |
hace 8 years |
|
I think carsten has hit the problem, I have always had probl... En el foro Others (Archive) |
hace 8 years |
|
I finally got to test your gcode. Printing is improved but u... En el foro Others (Archive) |
hace 8 years |
|
I have already done a lot of testing, but I'll try again. Wh... En el foro Others (Archive) |
hace 8 years |
|
Your prints are very good, with some finishing will be perfe... En el foro Others (Archive) |
hace 8 years |
|
i'm attaching the file En el foro Others (Archive) |
hace 8 years |
|
Of course, the fan is set to maximum. I did also attempts de... En el foro Others (Archive) |
hace 8 years |
|
I tried printing from outside to inside, just a little bette... En el foro Others (Archive) |
hace 8 years |
|
This is a continuous perimeter, I thought that the retractio... En el foro Others (Archive) |
hace 8 years |
|
printing problem at 0.1mm PLA En el foro Others (Archive) |
hace 8 years |
|
I printed marvin and it came out perfectly, the problem happ... En el foro Others (Archive) |
hace 8 years |
|
hi,
I have the same problem, even on other models, you have ... En el foro Others (Archive) |
hace 8 years |
