Notifications
Clear all
David Bartel
David Bartel
Skupina: Registrovaný
Přidal se: 2023/12/24
Active Member
1
No. I'm an old man (68) and not all that familiar with the m...

In forum Assembly and first prints troubleshooting

před 11 months
So, I am not a scientist. I'm a controls engineer. What I ob...

In forum Assembly and first prints troubleshooting

před 11 months
After reading your post I checked my heat bed. I used a lase...

In forum Assembly and first prints troubleshooting

před 11 months
I have a new MK4 running the latest firmware. I'm using a wi...

In forum Hardware, firmware and software help

před 12 months
I suppose "streaming" can be interpreted several ways. Give...

In forum General discussion, announcements and releases

před 12 months
Thank You for clearing that up. I though maybe I was missing...

In forum General discussion, announcements and releases

před 12 months
I saw in 5.1.0-alpha2 Firmware for Original Prusa MK4 they h...

In forum General discussion, announcements and releases

před 12 months
I tried an 8 GB usb stick and it does exactly the same thing...

In forum General discussion & User Experience & Ideas

před 12 months
The USB stick is a 32 GB USB Stick (its only using about 350...

In forum General discussion & User Experience & Ideas

před 12 months
Prusa Connect fails to transfer to USB drive

In forum General discussion & User Experience & Ideas

před 12 months
Thank you TeamD3dp. Its a newly assembled kit and I tuned th...

In forum Assembly and first prints troubleshooting

před 12 months
Sorry the cracking picture dident really come thru

In forum Assembly and first prints troubleshooting

před 12 months
I want to thank you both for your feedback. I re-designed my...

In forum Assembly and first prints troubleshooting

před 12 months
MK4 Warping seperation

In forum Assembly and first prints troubleshooting

před 12 months
I did something really dumb and caused all kinds of problems...

In forum Assembly and first prints troubleshooting

před 12 months
I'd like to clarify. That was with the Z axis in the full up...

In forum Assembly and first prints troubleshooting

před 12 months
Load Cell Reading

In forum Assembly and first prints troubleshooting

před 12 months
Share: