Notifications
Clear all
DanielV
DanielV
Skupina: Registrovaný
Přidal se: 2016/06/03
Eminent Member
2
I guess this is the important point. Thanks 🙂

In forum General discussion, announcements and releases

před 3 years
CC BY-NC-ND 4.0

In forum General discussion, announcements and releases

před 3 years
Hmmm. I got it to remove the nozzle. It was very thight, eve...

In forum Assembly and first prints troubleshooting

před 7 years
I will try this. So only a few E3D-Extruder have this proble...

In forum Assembly and first prints troubleshooting

před 7 years
Sorry for joining this conversation. I started reading this ...

In forum Assembly and first prints troubleshooting

před 7 years
Did anyone printed ABS with MMU? Even Single-Extrsion.

In forum Others (Archive)

před 7 years
A blockage, I guess.

In forum Others (Archive)

před 7 years
I see. You think the ABS is too hot to carry next layer? I'...

In forum Others (Archive)

před 8 years
You think cooling does the trick? I afraid warping when cool...

In forum Others (Archive)

před 8 years
Hey David, please explain. I even controlled the layer-cha...

In forum Others (Archive)

před 8 years
Here is the .stl and the used .gcode. This config will total...

In forum Others (Archive)

před 8 years
This was my first guess too. BUT: Layer-change happens exact...

In forum Others (Archive)

před 8 years
Hi there, It seems that reducing speed can solve this probl...

In forum Others (Archive)

před 8 years
Printing hollow objects with ABS

In forum Others (Archive)

před 8 years
so i'm doing right. "I print PLA with cooling. ABS complete...

In forum Others (Archive)

před 8 years
Hi there Daniel, How big an effect does environmental differ...

In forum Others (Archive)

před 8 years
Hi Erwin, I had a similar problem with no good solution. Bu...

In forum Others (Archive)

před 8 years
Hi, Most of my models are made with tinkercad. It runs in b...

In forum Others (Archive)

před 8 years
There are many causes of the problem. I printed many kinds ...

In forum Others (Archive)

před 8 years
You are right. This will become a problem with taller object...

In forum Others (Archive)

před 8 years
Stránka 1 / 3
Share: