Notifications
Clear all
daniel.e24
Skupina: Registrovaný
Přidal se: 2019/01/31
Active Member
1
| Filament trapped inside extruder PTFE tubing... | před 5 years | |
| Check the length. It should be 45mm. If it is 50 you have an... | před 6 years | |
| Well how silly of me! I figured out that if I unscrew the he... | před 6 years | |
| PTFE Tube on Hotend Assembly too long? | před 6 years | |
| I tried again, and the problem seems to have fixed itself. P... | před 6 years | |
| Things I'd check: * Y-axis rails and bearings * Right front... | před 6 years | |
| Incredibly uneven first layer... | před 6 years | |
| Daniel, Once you get the nozzle loosened at 280c, you may w... | před 6 years | |
| You'll need to heat it before trying to unscrew anything, pe... | před 6 years | |
| Cannot unscrew heatsink from hotend... | před 6 years | |
| Has anyone tried AmazonBasics filament? The reviews on Amazo... | před 6 years | |
| I did notice a small bit of plastic with the E-Axis printed ... | před 6 years | |
| Extruder too tight, even with door open... | před 6 years |