Prusa3D Forum

Notifications

Clear all

daniel.a2

Grupa: Zarejestrowany

Dołączył: 2016/11/25

Active Member

	I looked at everything again and the belt and pulley seemed ... In forum Others (Archive)	8 years temu
	Gab - thanks for the tip. I upgraded the firmware to 3.0.10... In forum Others (Archive)	8 years temu
	Y offset problems then X offset problems In forum Others (Archive)	8 years temu
	Janik, Ryan, David, After fine tuning the PINDA positioning... In forum Prusa i3 kit (Archive)	8 years temu
	I used an even lower value for Z adjust but am still not get... In forum Prusa i3 kit (Archive)	8 years temu
	Things actually stick to the hot bed pretty nicely. The Z Li... In forum Prusa i3 kit (Archive)	8 years temu
	Thanks David. Here is what it looks like when using the V2 C... In forum Prusa i3 kit (Archive)	8 years temu
	Can only print basic stuff successfully In forum Prusa i3 kit (Archive)	8 years temu
	I had to travel on business for a while but finally got to t... In forum Prusa i3 kit (Archive)	8 years temu
	I hope this time it works: ... In forum Prusa i3 kit (Archive)	8 years temu
	Sorry, not sure why Google Drive is giving me so much pain s... In forum Prusa i3 kit (Archive)	8 years temu
	Print quality issues In forum Prusa i3 kit (Archive)	8 years temu
	It's looking good now. Thank you much Peter and Joan! In forum Others (Archive)	8 years temu
	To make sure I understand, if in the diagram below corner C ... In forum Others (Archive)	8 years temu
	Leveling the Y-Axis assembly In forum Others (Archive)	8 years temu

Statystyki Forum

566 Fora

63.1 K Tematy

444.1 K Posty

26 Online

68.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte