Prusa3D Forum

Notifications

Clear all

daniel.a2

Skupina: Registrovaný

Přidal se: 2016/11/25

Active Member

	I looked at everything again and the belt and pulley seemed ... In forum Others (Archive)	před 8 years
	Gab - thanks for the tip. I upgraded the firmware to 3.0.10... In forum Others (Archive)	před 8 years
	Y offset problems then X offset problems In forum Others (Archive)	před 8 years
	Janik, Ryan, David, After fine tuning the PINDA positioning... In forum Prusa i3 kit (Archive)	před 8 years
	I used an even lower value for Z adjust but am still not get... In forum Prusa i3 kit (Archive)	před 8 years
	Things actually stick to the hot bed pretty nicely. The Z Li... In forum Prusa i3 kit (Archive)	před 8 years
	Thanks David. Here is what it looks like when using the V2 C... In forum Prusa i3 kit (Archive)	před 8 years
	Can only print basic stuff successfully In forum Prusa i3 kit (Archive)	před 8 years
	I had to travel on business for a while but finally got to t... In forum Prusa i3 kit (Archive)	před 8 years
	I hope this time it works: ... In forum Prusa i3 kit (Archive)	před 8 years
	Sorry, not sure why Google Drive is giving me so much pain s... In forum Prusa i3 kit (Archive)	před 8 years
	Print quality issues In forum Prusa i3 kit (Archive)	před 8 years
	It's looking good now. Thank you much Peter and Joan! In forum Others (Archive)	před 8 years
	To make sure I understand, if in the diagram below corner C ... In forum Others (Archive)	před 8 years
	Leveling the Y-Axis assembly In forum Others (Archive)	před 8 years

Fórum Statistiky

566 Fóra

63.1 K Témata

444.1 K Příspěvky

23 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed