|
I looked at everything again and the belt and pulley seemed ... En el foro Others (Archive) |
hace 8 years |
|
Gab - thanks for the tip.
I upgraded the firmware to 3.0.10... En el foro Others (Archive) |
hace 8 years |
|
Y offset problems then X offset problems En el foro Others (Archive) |
hace 8 years |
|
Janik, Ryan, David,
After fine tuning the PINDA positioning... En el foro Prusa i3 kit (Archive) |
hace 8 years |
|
I used an even lower value for Z adjust but am still not get... En el foro Prusa i3 kit (Archive) |
hace 8 years |
|
Things actually stick to the hot bed pretty nicely. The Z Li... En el foro Prusa i3 kit (Archive) |
hace 8 years |
|
Thanks David. Here is what it looks like when using the V2 C... En el foro Prusa i3 kit (Archive) |
hace 8 years |
|
Can only print basic stuff successfully En el foro Prusa i3 kit (Archive) |
hace 8 years |
|
I had to travel on business for a while but finally got to t... En el foro Prusa i3 kit (Archive) |
hace 8 years |
|
I hope this time it works:
... En el foro Prusa i3 kit (Archive) |
hace 8 years |
|
Sorry, not sure why Google Drive is giving me so much pain s... En el foro Prusa i3 kit (Archive) |
hace 8 years |
|
Print quality issues En el foro Prusa i3 kit (Archive) |
hace 8 years |
|
It's looking good now. Thank you much Peter and Joan! En el foro Others (Archive) |
hace 8 years |
|
To make sure I understand, if in the diagram below corner C ... En el foro Others (Archive) |
hace 8 years |
|
Leveling the Y-Axis assembly En el foro Others (Archive) |
hace 8 years |
