Crab – Activité – Prusa3D Forum

Notifications

Clear all

Crab

Groupe: Enregistré

A(ont) rejoint: 2022/03/03

Reputable Member

	Cheap webcam option for monitoring prints Dans le forum User mods - OctoPrint, enclosures, nozzles, ...	il y a 3 years
	I just discovered I had a crossed line in my black spool. It... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Can't seem to dial in my PolyTerra Blk PLA Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Do I need to enter Z offset into Printer Settings? Dans le forum PrusaSlicer	il y a 3 years
	Thanks to all that helped.. the lowered Z axis did the trick... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Here was the current setting (-1.100 on right) and I cleaned... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	I have the Z at about -1.1 .. I had seen that and it appeare... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	I did clean with 99% IPA, but I did not wash.. I will do and... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Noobie: Kit: Benchy spaghetti.. what do I tune? Dans le forum Assembly and first prints troubleshooting	il y a 3 years

Page 23 / 23 Précédent

Statistiques du forum

566 Forums

63.2 K Sujets

444.5 K Messages

20 En-ligne

68.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé