Notifications
Clear all
Crab
Skupina: Registrovaný
Přidal se: 2022/03/03
Reputable Member
5
|
Thanks.. just submitted. In forum Hardware, firmware and software help |
před 3 years | |
| Is PolyTerra Cardboard spool a good thing? (moisture) | před 3 years | |
|
Firmware suggestion In forum Hardware, firmware and software help |
před 3 years | |
| Agreed. It’s only if you want a home webcam that will do dou... | před 3 years | |
| Cheap webcam option for monitoring prints | před 3 years | |
| I just discovered I had a crossed line in my black spool. It... | před 3 years | |
| Can't seem to dial in my PolyTerra Blk PLA | před 3 years | |
|
Do I need to enter Z offset into Printer Settings? In forum PrusaSlicer |
před 3 years | |
| Thanks to all that helped.. the lowered Z axis did the trick... | před 3 years | |
| Here was the current setting (-1.100 on right) and I cleaned... | před 3 years | |
| I have the Z at about -1.1 .. I had seen that and it appeare... | před 3 years | |
| I did clean with 99% IPA, but I did not wash.. I will do and... | před 3 years | |
| Noobie: Kit: Benchy spaghetti.. what do I tune? | před 3 years |
Stránka 23 / 23
Předchozí