Aktywność
 
Notifications
Clear all
corey.a
corey.a
Grupa: Zarejestrowany
Dołączył: 2016/10/15
Trusted Member
3
Adjusting filament cooling move distance in firmware

In forum Hardware, firmware and software help

6 years temu
This is my first guess within the config_prusa.h file. Not ...

In forum Hardware, firmware and software help

6 years temu
Been a while, Any idea how to change the retract length in ...

In forum Hardware, firmware and software help

6 years temu
Update: The error was due to replacing the config.h file wi...

In forum Hardware, firmware and software help

6 years temu
Update: I also managed to change "what I think" is the corr...

In forum Hardware, firmware and software help

6 years temu
Update: Getting an error when verifying Firmware.ino in ard...

In forum Hardware, firmware and software help

6 years temu
Update: I was able to download the Prusa repository from Gi...

In forum Hardware, firmware and software help

6 years temu
Update: Found the .h file under: "Prusa-Firmware/Firmware/...

In forum Hardware, firmware and software help

6 years temu
How To Download Firmware and Modify Extruder Speed

In forum Hardware, firmware and software help

6 years temu
Heres the pics for that earlier post:

In forum Hardware, firmware and software help

6 years temu
Trying to revive this post as Prusa forums were down for a b...

In forum Hardware, firmware and software help

6 years temu
All motors are good. I tested them on the port for extruder...

In forum Hardware, firmware and software help

6 years temu
Peter, Just now saw your post after Joan's. I'll start wig...

In forum Hardware, firmware and software help

6 years temu
Hi Joan, I have the latest version dowloaded on my printer ...

In forum Hardware, firmware and software help

6 years temu
MM setup: only one extruder activates when loading 1-4

In forum Hardware, firmware and software help

6 years temu
Thanks again. I have Cura 3.3.1 and managed to find some sy...

In forum Hardware, firmware and software help

7 years temu
Thanks Peter, Would you happen to know the syntax for Cura ...

In forum Hardware, firmware and software help

7 years temu
G-Code Issue

In forum Hardware, firmware and software help

7 years temu
Hey guys, Thanks for the info, this helps alot. However, I...

In forum Prusa i3 kit (Archive)

7 years temu
Hi Aaron, A"printinz" plate is a thick printing surface for...

In forum Prusa i3 kit (Archive)

7 years temu
Strona 1 / 3
Share: