Activité
 
Notifications
Clear all
corey.a
corey.a
Groupe: Enregistré
A(ont) rejoint: 2016/10/15
Trusted Member
3
Adjusting filament cooling move distance in firmware

Dans le forum Hardware, firmware and software help

il y a 6 years
This is my first guess within the config_prusa.h file. Not ...

Dans le forum Hardware, firmware and software help

il y a 6 years
Been a while, Any idea how to change the retract length in ...

Dans le forum Hardware, firmware and software help

il y a 6 years
Update: The error was due to replacing the config.h file wi...

Dans le forum Hardware, firmware and software help

il y a 6 years
Update: I also managed to change "what I think" is the corr...

Dans le forum Hardware, firmware and software help

il y a 6 years
Update: Getting an error when verifying Firmware.ino in ard...

Dans le forum Hardware, firmware and software help

il y a 6 years
Update: I was able to download the Prusa repository from Gi...

Dans le forum Hardware, firmware and software help

il y a 6 years
Update: Found the .h file under: "Prusa-Firmware/Firmware/...

Dans le forum Hardware, firmware and software help

il y a 6 years
How To Download Firmware and Modify Extruder Speed

Dans le forum Hardware, firmware and software help

il y a 6 years
Heres the pics for that earlier post:

Dans le forum Hardware, firmware and software help

il y a 6 years
Trying to revive this post as Prusa forums were down for a b...

Dans le forum Hardware, firmware and software help

il y a 6 years
All motors are good. I tested them on the port for extruder...

Dans le forum Hardware, firmware and software help

il y a 6 years
Peter, Just now saw your post after Joan's. I'll start wig...

Dans le forum Hardware, firmware and software help

il y a 6 years
Hi Joan, I have the latest version dowloaded on my printer ...

Dans le forum Hardware, firmware and software help

il y a 6 years
MM setup: only one extruder activates when loading 1-4

Dans le forum Hardware, firmware and software help

il y a 6 years
Thanks again. I have Cura 3.3.1 and managed to find some sy...

Dans le forum Hardware, firmware and software help

il y a 7 years
Thanks Peter, Would you happen to know the syntax for Cura ...

Dans le forum Hardware, firmware and software help

il y a 7 years
G-Code Issue

Dans le forum Hardware, firmware and software help

il y a 7 years
Hey guys, Thanks for the info, this helps alot. However, I...

Dans le forum Prusa i3 kit (Archive)

il y a 7 years
Hi Aaron, A"printinz" plate is a thick printing surface for...

Dans le forum Prusa i3 kit (Archive)

il y a 7 years
Page 1 / 3
Partager :