|
Adjusting filament cooling move distance in firmware In forum Hardware, firmware and software help |
6 years ago |
|
This is my first guess within the config_prusa.h file. Not ... In forum Hardware, firmware and software help |
6 years ago |
|
Been a while,
Any idea how to change the retract length in ... In forum Hardware, firmware and software help |
6 years ago |
|
Update:
The error was due to replacing the config.h file wi... In forum Hardware, firmware and software help |
6 years ago |
|
Update:
I also managed to change "what I think" is the corr... In forum Hardware, firmware and software help |
6 years ago |
|
Update:
Getting an error when verifying Firmware.ino in ard... In forum Hardware, firmware and software help |
6 years ago |
|
Update:
I was able to download the Prusa repository from Gi... In forum Hardware, firmware and software help |
6 years ago |
|
Update:
Found the .h file under: "Prusa-Firmware/Firmware/... In forum Hardware, firmware and software help |
6 years ago |
|
How To Download Firmware and Modify Extruder Speed In forum Hardware, firmware and software help |
6 years ago |
|
Heres the pics for that earlier post: In forum Hardware, firmware and software help |
6 years ago |
|
Trying to revive this post as Prusa forums were down for a b... In forum Hardware, firmware and software help |
6 years ago |
|
All motors are good. I tested them on the port for extruder... In forum Hardware, firmware and software help |
6 years ago |
|
Peter,
Just now saw your post after Joan's. I'll start wig... In forum Hardware, firmware and software help |
6 years ago |
|
Hi Joan,
I have the latest version dowloaded on my printer ... In forum Hardware, firmware and software help |
6 years ago |
|
MM setup: only one extruder activates when loading 1-4 In forum Hardware, firmware and software help |
6 years ago |
|
Thanks again.
I have Cura 3.3.1 and managed to find some sy... In forum Hardware, firmware and software help |
6 years ago |
|
Thanks Peter,
Would you happen to know the syntax for Cura ... In forum Hardware, firmware and software help |
6 years ago |
|
G-Code Issue In forum Hardware, firmware and software help |
6 years ago |
|
Hey guys,
Thanks for the info, this helps alot. However, I... In forum Prusa i3 kit (Archive) |
7 years ago |
|
Hi Aaron,
A"printinz" plate is a thick printing surface for... In forum Prusa i3 kit (Archive) |
7 years ago |
