Prusa3D Forum

Notifications

Clear all

colezajicek

Group: Registered

Joined: 2017/12/12

Active Member

	Ok, cool. I'm not too worried about physically assembling it... In forum Hardware, firmware and software help	7 years ago
	So I checked out the upgrade, and read through your thread a... In forum Hardware, firmware and software help	7 years ago
	Z-axis expansion In forum Hardware, firmware and software help	7 years ago
	Second completely unplugging the filament sensor. It caused ... In forum Others (Archive)	7 years ago
	Looks like a solid design to me. Where is everyone wiring t... In forum Others (Archive)	7 years ago
	i figured it out, its a firmware issue! I was on the latest... In forum Others (Archive)	7 years ago
	ABS curling and overhang failures In forum Others (Archive)	7 years ago
	Spent a couple hour chatting with support yesterday while di... In forum Others (Archive)	7 years ago
	Cold pull came out as perfect as it gets, so it's not a bloc... In forum Others (Archive)	7 years ago
	I also just read this post: My clicking stated before I mo... In forum Others (Archive)	7 years ago
	I'm not sure about the rust, I also noticed it mentioned in ... In forum Others (Archive)	7 years ago
	With the extruder cleaned up. Not sure if the deformed lower... In forum Others (Archive)	7 years ago
	This is the initial view of what my filament is doing on the... In forum Others (Archive)	7 years ago
	I'm having the same issue, I've tried printing at different ... In forum Others (Archive)	7 years ago

Forum Statistics

565 Forums

63.9 K Topics

447.7 K Posts

22 Online

69.6 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed