Prusa3D Forum

Notifications

Clear all

Coler2002

Groupe: Enregistré

A(ont) rejoint: 2016/09/18

Active Member

	Check out that thread. The last comment said the 3mil was th... Dans le forum Others (Archive)	il y a 8 years
	I hope someone can confirm this because I don't wanna spend ... Dans le forum Others (Archive)	il y a 8 years
	After reading more I am convinced that these are the "seams"... Dans le forum Others (Archive)	il y a 8 years
	Did anyone find out a fix for this?? I am having a similar p... Dans le forum Print tips (Archive)	il y a 8 years
	The postage is killer. My mk2s upgrade kit cost over 80 by t... Dans le forum Others (Archive)	il y a 8 years
	Printing Flaws Dans le forum Others (Archive)	il y a 8 years
	NinjaFlex this stuff sticks! Dans le forum Others (Archive)	il y a 8 years
	I have gotten this many times it seems to go away with a few... Dans le forum Others (Archive)	il y a 8 years
	I had the same problem and no one answered me. The issue is ... Dans le forum Others (Archive)	il y a 8 years
	I have seen this error message too. I was assuming it was be... Dans le forum Others (Archive)	il y a 8 years
	Filament change effect on Z offset Dans le forum Others (Archive)	il y a 8 years
	So am I hitting export before slic3r has finished making the... Dans le forum Others (Archive)	il y a 8 years
	Printer freezing/hanging Dans le forum Others (Archive)	il y a 8 years

Statistiques du forum

565 Forums

64.5 K Sujets

451.8 K Messages

24 En-ligne

71.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé