Prusa3D Forum

Notifications

Clear all

Codeplayer

Grupa: Zarejestrowany

Dołączył: 2017/01/25

Active Member

	Doesn't it work like this already? If I run out of filament ... In forum Assembly and first prints troubleshooting	2 years temu
	You should set the sensitivity to 10 if you run 12V system w... In forum Assembly and first prints troubleshooting	2 years temu
	I am half way there. To get the idler working, you have to t... In forum Hardware, firmware and software help	2 years temu
	MK2 is supported, but the only one that has no profile to se... In forum PrusaSlicer	6 years temu

Statystyki Forum

595 Fora

69.5 K Tematy

486.4 K Posty

15 Online

79.3 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte