Prusa3D Forum

Notifications

Clear all

Codeplayer

Skupina: Registrovaný

Přidal se: 2017/01/25

Active Member

	Doesn't it work like this already? If I run out of filament ... In forum Assembly and first prints troubleshooting	před 2 years
	You should set the sensitivity to 10 if you run 12V system w... In forum Assembly and first prints troubleshooting	před 2 years
	I am half way there. To get the idler working, you have to t... In forum Hardware, firmware and software help	před 2 years
	MK2 is supported, but the only one that has no profile to se... In forum PrusaSlicer	před 6 years

Fórum Statistiky

595 Fóra

69.5 K Témata

486.5 K Příspěvky

18 Online

79.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed