|
Hi,
just made a test based on what is discussed there, usin... In forum Others (Archive) |
9 years ago |
|
@Peter, You don't have to feel sorry ^^
However since it sh... In forum Software (Archive) |
10 years ago |
|
Adding skip detection during firmware self-test In forum Software (Archive) |
10 years ago |
|
@Nigel: Yes I agree but since OP tell that he wants to let t... In forum Others (Archive) |
10 years ago |
|
In your case, a printing enclosure may help to prevent issue... In forum Others (Archive) |
10 years ago |
|
Hi Janis,
I just printed your gcode with no issue on the to... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Hi Peter,
Yes I have the 1.7.3 package, and I do not use US... In forum Others (Archive) |
10 years ago |
|
I'm a bit confused.
I tried multiple times to go to 3.0.5 R... In forum Others (Archive) |
10 years ago |
|
Ok Peter, I understand better now, I was sure it was not all... In forum Improvements (Archive) |
10 years ago |
|
Just realised that the graph are in wrong order.
Sorry for ... In forum Improvements (Archive) |
10 years ago |
|
Ok, a quick update:
Rebooting my computer fix my write den... In forum Others (Archive) |
10 years ago |
|
Hi, back from travel I wanted to give a go to this Firmware,... In forum Others (Archive) |
10 years ago |
|
HI Andreas,
I used a 55 × 55 cm (10 mm width) cork tile and... In forum Others (Archive) |
10 years ago |
|
I was as surprised as you ^^
It was on a stl exported from ... In forum Software (Archive) |
10 years ago |
|
Hi Prusayo,
For the record, the application that gave me th... In forum Software (Archive) |
10 years ago |
|
Hi Shree
Something like that should be a better solution: In forum Others (Archive) |
10 years ago |
|
Hi Peter,
That's a clever deduction. Then the very first st... In forum Others (Archive) |
10 years ago |
|
I made some measurement before and after using Octoprint.
S... In forum Improvements (Archive) |
10 years ago |
|
MK2 HeatBed insulation In forum Improvements (Archive) |
10 years ago |
|
Since I'm using mostly 110 °C as first layer temperature for... In forum Others (Archive) |
10 years ago |
