Notifications
Clear all
christophe.p
christophe.p
Groupe: Modérateur
A(ont) rejoint: 2016/02/14
Titre: Membre Moderator
1
Hi, just made a test based on what is discussed there, usin...

Dans le forum Others (Archive)

il y a 8 years
@Peter, You don't have to feel sorry ^^ However since it sh...

Dans le forum Software (Archive)

il y a 8 years
Adding skip detection during firmware self-test

Dans le forum Software (Archive)

il y a 8 years
@Nigel: Yes I agree but since OP tell that he wants to let t...

Dans le forum Others (Archive)

il y a 8 years
In your case, a printing enclosure may help to prevent issue...

Dans le forum Others (Archive)

il y a 8 years
Hi Janis, I just printed your gcode with no issue on the to...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
Hi Peter, Yes I have the 1.7.3 package, and I do not use US...

Dans le forum Others (Archive)

il y a 8 years
I'm a bit confused. I tried multiple times to go to 3.0.5 R...

Dans le forum Others (Archive)

il y a 8 years
Ok Peter, I understand better now, I was sure it was not all...

Dans le forum Improvements (Archive)

il y a 8 years
Just realised that the graph are in wrong order. Sorry for ...

Dans le forum Improvements (Archive)

il y a 8 years
Ok, a quick update: Rebooting my computer fix my write den...

Dans le forum Others (Archive)

il y a 8 years
Hi, back from travel I wanted to give a go to this Firmware,...

Dans le forum Others (Archive)

il y a 8 years
HI Andreas, I used a 55 × 55 cm (10 mm width) cork tile and...

Dans le forum Others (Archive)

il y a 8 years
I was as surprised as you ^^ It was on a stl exported from ...

Dans le forum Software (Archive)

il y a 8 years
Hi Prusayo, For the record, the application that gave me th...

Dans le forum Software (Archive)

il y a 8 years
Hi Shree Something like that should be a better solution:

Dans le forum Others (Archive)

il y a 8 years
Hi Peter, That's a clever deduction. Then the very first st...

Dans le forum Others (Archive)

il y a 8 years
I made some measurement before and after using Octoprint. S...

Dans le forum Improvements (Archive)

il y a 8 years
MK2 HeatBed insulation

Dans le forum Improvements (Archive)

il y a 8 years
Since I'm using mostly 110 °C as first layer temperature for...

Dans le forum Others (Archive)

il y a 8 years
Page 18 / 29
Partager :