Notifications
Clear all
chrischin
chrischin
Grupa: Zarejestrowany
Dołączył: 2018/12/15
Trusted Member
3
Turns out I was putting the second temperature commands afte...

In forum PrusaSlicer

2 months temu
Start G-code Omitted from Sliced G-code 2.8.0

In forum PrusaSlicer

2 months temu
Thanks so much for the recommended settings and detailed exp...

In forum PrusaSlicer

8 months temu
Interesting. I've read through several of these posts but ju...

In forum PrusaSlicer

8 months temu
If I print with no infill the gap issue is mostly gone (thir...

In forum PrusaSlicer

8 months temu
Extrusion gap near seam/deretraction

In forum PrusaSlicer

8 months temu
Actually, I tried this again and it does fix it. I was getti...

In forum PrusaSlicer

11 months temu
Ah, I see what you're saying about the infill, but one thing...

In forum PrusaSlicer

11 months temu
Thanks. But why wouldn't the gap exist at the outer edge, un...

In forum PrusaSlicer

11 months temu
Overhang Gap

In forum PrusaSlicer

11 months temu
Confirmed, Prusa docs say this about the thin walls setting:...

In forum PrusaSlicer

2 years temu
But the seam looks as smooth as can be on the Classic settin...

In forum PrusaSlicer

2 years temu
Print just finished with 0.6mm nozzle QUALITY profile and al...

In forum PrusaSlicer

2 years temu
Thanks. I did also notice some z artifacts on my print, whic...

In forum PrusaSlicer

2 years temu
How could Arachne possibly be the default when it's so unrel...

In forum PrusaSlicer

2 years temu
Attached zipped PrusaSlicer Project file  Box-Arachne...

In forum PrusaSlicer

2 years temu
Seams Issue with Arachne

In forum PrusaSlicer

2 years temu
@edg-engineering-2 I think I just accepted these gaps and di...

In forum How do I print this? (Printing help)

4 years temu
@chocki Nice! Have you considered a volcano hot end upgrade?...

In forum How do I print this? (Printing help)

5 years temu
@bobstro In the before gcode I turned down the "M221 S95" co...

In forum How do I print this? (Printing help)

5 years temu
Strona 1 / 3
Share: