Prusa3D Forum

Notifiche

Cancella tutti

chrischin

Gruppo: Registrato

Registrato: 2018/12/15

Trusted Member

	Rough layer lines near corner Nel forum How do I print this? (Printing help)	3 months fa
	Turns out I was putting the second temperature commands afte... Nel forum PrusaSlicer	12 months fa
	Start G-code Omitted from Sliced G-code 2.8.0 Nel forum PrusaSlicer	12 months fa
	Thanks so much for the recommended settings and detailed exp... Nel forum PrusaSlicer	1 year fa
	Interesting. I've read through several of these posts but ju... Nel forum PrusaSlicer	1 year fa
	If I print with no infill the gap issue is mostly gone (thir... Nel forum PrusaSlicer	1 year fa
	Extrusion gap near seam/deretraction Nel forum PrusaSlicer	1 year fa
	Actually, I tried this again and it does fix it. I was getti... Nel forum PrusaSlicer	2 years fa
	Ah, I see what you're saying about the infill, but one thing... Nel forum PrusaSlicer	2 years fa
	Thanks. But why wouldn't the gap exist at the outer edge, un... Nel forum PrusaSlicer	2 years fa
	Overhang Gap Nel forum PrusaSlicer	2 years fa
	Confirmed, Prusa docs say this about the thin walls setting:... Nel forum PrusaSlicer	3 years fa
	But the seam looks as smooth as can be on the Classic settin... Nel forum PrusaSlicer	3 years fa
	Print just finished with 0.6mm nozzle QUALITY profile and al... Nel forum PrusaSlicer	3 years fa
	Thanks. I did also notice some z artifacts on my print, whic... Nel forum PrusaSlicer	3 years fa
	How could Arachne possibly be the default when it's so unrel... Nel forum PrusaSlicer	3 years fa
	Attached zipped PrusaSlicer Project file Box-Arachne... Nel forum PrusaSlicer	3 years fa
	Seams Issue with Arachne Nel forum PrusaSlicer	3 years fa
	@edg-engineering-2 I think I just accepted these gaps and di... Nel forum How do I print this? (Printing help)	5 years fa
	@chocki Nice! Have you considered a volcano hot end upgrade?... Nel forum How do I print this? (Printing help)	5 years fa

Pagina 1 / 3 Avanti

Statistiche Forum

585 Forum

68.1 K Discussioni

477 K Post

12 Online

75.8 K Utenti

Post recenti: Prusaslicer 2.9.3 September 12 release on Linux Ultimo utente registrato: Tommy Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso