Notifications
Clear all
Chris P
Chris P
Skupina: Registrovaný
Přidal se: 2020/05/12
Eminent Member
2
@neophyl Thank you very much for offering to look at the fil...

In forum How do I print this? (Printing help)

před 4 years
@neophyl Thanks for the reply. I do use the slider but hones...

In forum How do I print this? (Printing help)

před 4 years
@neophyl I don't think so. Is this the view you mean?

In forum How do I print this? (Printing help)

před 4 years
@vintagepc Thanks for the response. The artifact on the hull...

In forum How do I print this? (Printing help)

před 4 years
I printed the temperature tower and I'm pretty surprised. If...

In forum How do I print this? (Printing help)

před 4 years
Can't figure out what is happening...

In forum How do I print this? (Printing help)

před 4 years
Gradient infill - how?

In forum How do I print this? (Printing help)

před 4 years
My son loves it!  Mask-print.jpg

In forum How do I print this? (Printing help)

před 4 years
@jsw I tried your suggestions and setting and it worked grea...

In forum How do I print this? (Printing help)

před 4 years
@jsw Thanks again! I will try what you suggest!

In forum How do I print this? (Printing help)

před 4 years
@jsw Thanks for the reply. Yes, my printer seems to be fine....

In forum How do I print this? (Printing help)

před 4 years
First time with supports and not very successful

In forum How do I print this? (Printing help)

před 4 years
@manelto Thank you so much for the information and video!!

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 4 years
New user nozzle questions...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 4 years
Firmware update and first layer calibration

In forum Hardware, firmware and software help

před 4 years
@peter-k42 Thank you!

In forum Assembly and first prints troubleshooting

před 4 years
Here's a link to a video of the noises. It is in the very be...

In forum Assembly and first prints troubleshooting

před 4 years
Curious about a noise - is it normal?

In forum Assembly and first prints troubleshooting

před 4 years
Thank you both for the information!

In forum General discussion, announcements and releases

před 4 years
What filament/material can be used in the mouth?

In forum General discussion, announcements and releases

před 4 years
Stránka 2 / 2
Share: